nativetexan
New Member
- Joined
- Dec 29, 2010
- Messages
- 25
I have had my at pro for about a month now. This is my first detector and I have put about 40 hours on it. Most of those have been in standard coin mode. When I try Custom mode coin all I get is constant low level noise. If I get a good signal in standard mode I get the high bell tone so I have been switching over to pro mode on target but I just get the very low iron type audio. The vdi will show the same as it did in standard mode. Is this normal? If I try pro mode I have to just look at vdi constantly to see if I go over a good target. Why would someone want the constant chatter instead of a clear tone when something is detected like in standard mode. Also my pinpointer id bar seems to be fading out on occasion like the screen is going bad. thanks