fracturedtundra
New Member
Hi Everyone, I am having a problem with my new Ace 350 and hope that someone can please help me out. The MD works just fine when sweeping side to side. The readout is good and the tones are just as they should be. Pinpointing is the issue. When I find a target and press the pinpoint button I immediately get a tone that is loud and cannot get that tone to stop. I can point the MD in the air with the pinpoint button pressed and still get the tone and it will not fall off as it should. What is happening here? Is there a way to reset? I have pulled the batteries and replaced them, disconnected the cable and put back on, checked sensitivity, cleaned the coil and tried different modes but nothing seems to work. Still get the tone all the time. The pinpointer worked fine the first few times I used it, but now seems to be on the fritz. Any help at all is welcome and appreciated. Thanks!!!