Seaking406
Elite Member
Spending most of this spring reading up and watching tutes online, I found that there is some discrepancy on what beach setting to use.. Most of what I had seen or read states that Beach1 would be used in dry sand while Beach2 would be used in wet sand (at water's edge, for example). But a recent Minelab tutorial states that Beach1 should be used for dry AND wet sand, while Beach2 should be used for underwater use.. Under water unit or underwater coil, they did not specify.. ?
So what's the correct mode when walking along at low tide in the wet wet sand area? I had always used the dry wet sand modes but now, wondering if that's wrong?
So what's the correct mode when walking along at low tide in the wet wet sand area? I had always used the dry wet sand modes but now, wondering if that's wrong?