wymanwvp32
Full Member
How do i determine where the object is located? when it beeps is the target in the center of the coil or at the edge of the coil where it first goes off? Thanks for the help!
targeting with a bounty hunter pioneer 202
- Thread starter wymanwvp32
- Start date
jrdavis119
Full Member
Well W-man...I'll give this a shot.....
It might depend on where you have your sensitivity/discrimination set. If it is set real high on Sen and low on Disc...it could be anywhere around your coil. My humble opinion is to slowly sweep your area and when you get a signal, back up and sweep the signal area again. If the signal is repeated, try from a different angle and sweep in an X pattern. Usually, this help to pinpoint directly over the target. I have a Pioneer BH 505 and this works pretty well for me. I have been playing with the Sen/Disc on mine to find the right combination for my area's soil. Right now - I set Sen about 1 O'clock and Disc about midpoint. If I set it too high, I get a really strong signal for iron on just a rusted fragment of nail, sometimes not much larger than a common pin. I'm certainly not an expert, but hope this helps you some. Best thing to do is keep swingin that baby til you get to know her...and have fun while yer doin it!!!! Good Luck
It might depend on where you have your sensitivity/discrimination set. If it is set real high on Sen and low on Disc...it could be anywhere around your coil. My humble opinion is to slowly sweep your area and when you get a signal, back up and sweep the signal area again. If the signal is repeated, try from a different angle and sweep in an X pattern. Usually, this help to pinpoint directly over the target. I have a Pioneer BH 505 and this works pretty well for me. I have been playing with the Sen/Disc on mine to find the right combination for my area's soil. Right now - I set Sen about 1 O'clock and Disc about midpoint. If I set it too high, I get a really strong signal for iron on just a rusted fragment of nail, sometimes not much larger than a common pin. I'm certainly not an expert, but hope this helps you some. Best thing to do is keep swingin that baby til you get to know her...and have fun while yer doin it!!!! Good Luck
