There will be occasions where pinpoint is tough to do and be accurate. Same goes for trying to dig under center of coil where best achievable signal is gotten.
Things that will drive - detection spot vs where target is? Freq used mono program, max freq used FMF, reactivity setting of detector, size of coil, amount of notch used ( depending on total nonferrous target layout ((conductivity levels)) in area where detection occurs.
The deeper a detected target gets. The more in line will be the spot of detection vs where target is under coil. When we consider possible maskers (ferrous and nonferrous).
Things that will drive - detection spot vs where target is? Freq used mono program, max freq used FMF, reactivity setting of detector, size of coil, amount of notch used ( depending on total nonferrous target layout ((conductivity levels)) in area where detection occurs.
The deeper a detected target gets. The more in line will be the spot of detection vs where target is under coil. When we consider possible maskers (ferrous and nonferrous).